Developer: Kodak Goldstar Premium plate developer 100%
Develop temperature: 22-24℃
Develop time: 30-35 seconds.
Finishing: KG-2, KG-2S
To increase the hydrophilicity of the non-image area and prevent
the plate from fingerprint and other contamination, you should use
(KG-2 or KG-2S, 8%-11% made by Gum Arabic) immediately after image
removing. Wipe the gum solution on the developed plate and dry it.
Gum solutions made by synthetic polymer are difficult to wash away
before printing and result in poor roll-up performance.
Deletion: KM-7(Gel), KM-1 & KM-2 (Pen)
To remove the unwanted image on non-image area, you can use Image
remover gel KM-7 or Deletion Pen KM-1,KM-2. Apply the image
Remover on the dry plate for about 10 seconds and wipe off the
residue. The residue on the plate will decrease the run-length.
Using Phoeneagle Deletion Pen will minimize the side effects to the
Remove unwanted image from plate with Deletion Pen, wipe the plate
with bake solution(KB-3) and heat at 220℃ for minutes. Before
printing, treat the baked plate with developer for 30 seconds, wash
with water thoroughly and then gumming.